Once we find a GAT table we like example gat id 2143563
We request X amount of numbers wheel them as we like
My question is
How do i use the same table for the next few draws.?
From what i gather,
do i update the draw history then run the scan again with RF set to 1 and retain gat id 2143563 ?
Or is there a faster way to get a fresh set of numbers for a particular gat id ?.
Perhaps i have completely misunderstood any help would be appreciated.
Regards
Iwinbig
Some questions about GAT tables and future draws
- lottoarchitect
- Site Admin
- Posts: 1635
- Joined: Tue Jan 15, 2008 5:03 pm
- Location: Greece
- Contact:
Re: Some questions about GAT tables and future draws
Hi Iwinbig, just add the new history draws as they come without changing any parameter (tested draws, stat.data, start point). You'll notice RF automatically adjusts according to how many new draws you have added since your initial run where you picked that GAT ID. Make sure you enter the GAT ID you seek for at the retain GATs panel at the options too; this is to ensure the engine will not discard this GAT ID (this may occur especially if Run Factor has increased a lot). Perform the scan to reach that GAT ID and use the numbers proposed. It is not possible to directly jump to a specific GAT ID, all the preceding IDs must be computed first.
Re: Some questions about GAT tables and future draws
Got it
Thank you
Thank you
Who is online
Users browsing this forum: No registered users and 9 guests